System settings
308
Display settings
Setting the brightness
The brightness detected by the display light
sensor affects the setting options for this
function.
Press W.
X
Select
Settings
X
COMAND controller and press W to con-
firm.
Select
Display
X
Select
Brightness
X
firm.
Adjust the brightness by turning cVd the
X
COMAND controller and press W to con-
firm.
Display design
Your COMAND display features optimized
designs for operation during daytime and
night-time hours. You can customize the
design by manually selecting day or night
design, or opt for an automatic setting.
Press W.
X
Select
Settings
X
COMAND controller and press W to con-
firm.
Select
Display
X
Select
Day
Mode,
X
matic
by turning cVd the COMAND con-
troller and press W to confirm.
A dot indicates the current setting.
by turning cVd the
and press W to confirm.
and press W to con-
by turning cVd the
and press W to confirm.
Night Mode
or
Auto‐
Design
Explanation
Day Mode
The display is set perma-
nently to day design.
Night Mode
The display is set perma-
nently to night design.
Automatic
If the
is selected, COMAND
evaluates the readings
from the automatic vehi-
cle light sensor and auto-
matically switches
between the display
designs.
Time settings
General information
If COMAND is equipped with a navigation sys-
tem and has GPS reception, COMAND auto-
matically sets the time and date. You can
change the time in minute increments. The
date can also be changed.
i
If you adjust the time in minute incre-
ments, any time zone settings and settings
for changing between summer and stand-
ard time are lost. Switching between sum-
mer and standard time (
i
The following navigation system functions
require the time, time zone and summer/
standard time to be set correctly in order to
work properly:
route guidance on routes with time-
R
dependent traffic guidance
calculation of expected time of arrival
R
i
With this function, you can set the time for
every display in the vehicle.
Setting the time/date format
Press the W button.
X
Select
Time
by turning c V d the COMAND
X
controller and press W to confirm.
Automatic
setting
page 309).
Y