Siemens SINUMERIK 828D Function Manual page 797

Hide thumbs Also See for SINUMERIK 828D:
Table of Contents

Advertisement

MD20110
Significance
Bit 0 = 0
TCARR and PAROT system frames are retained as before the RESET.
Bit 0 = 1
MD20152 $MC_GCODE_RESET_MODE[51] = 0
MD20150 $MC_GCODE_RESET_VALUES[51] = 1
MD20150 $MC_GCODE_RESET_VALUES[51] = 2
MD20152 $MC_GCODE_RESET_MODE[51] = 1
MD20152 $MC_GCODE_RESET_MODE[52] = 0
MD20150 $MC_GCODE_RESET_VALUES[52] = 1
MD20150 $MC_GCODE_RESET_VALUES[52] = 2
MD20150 $MC_GCODE_RESET_VALUES[52] = 3
MD20152 $MC_GCODE_RESET_MODE[52] = 1
TCARR and PAROT are two independent functions, which describe the same frame. With PAROTOF, the
component of TCARR is not activated on RESET.
MD20110
Bit 0 = 1 and bit 14 = 0
Bit 0 = 1 and bit 14 = 1
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Significance
Chained complete basic frame is deleted.
The complete basic frame is derived on the basis of:
MD24002 $MC_CHBFRAME_RESET_MASK
(active channel-specific basic frame after RESET)
and
MD10613 $MN_NCBFRAME_RESET_MASK
(active NCU global basic frame after RESET)
MD24002 $MC_CHBFRAME_RESET_MASK
Bit 0 = 1
1. Channel basic frame is calculated into the chained
complete basic frame.
Bit 7 = 1
8. Channel basic frame is calculated into the chained
complete basic frame.
MD10613 $MN_NCBFRAME_RESET_MASK
Bit 0 = 1
1. NCU global basic frame is calculated into the chained
complete basic frame.
Bit 7 = 1
8. NCU global basic frame is calculated into the chained
complete basic frame.
K2: Axis Types, Coordinate Systems, Frames
PAROTOF
PAROT
TCARR and PAROT
system frames are retained
as before the RESET.
TOROTOF
TOROT
TOFRAME
TOROT and TOFRAME
system frames are retained
as before the RESET.
10.5  Frames 
797

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 840d sl

Table of Contents