Siemens SINUMERIK 828D Function Manual page 379

Parameter sets during gear stage change
Interpolation parameter sets during gear stage change:
In the case of spindles, each gear stage is assigned its own parameter set.
Dependent on the NC/PLC interface signal:
DB31, ... DBX16.0 - 16.2 (actual gear stage)
the corresponding parameter set is activated.
DB31, ... DBX16.0 - 16.2 (actual gear stage)
000
001
010
011
100
101
110
111
For more information on gear stages for spindles see:
References:
/FB1/ Function Manual Basic Functions; Spindles (S1)
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
G2: Velocities, setpoint / actual value systems, closed-loop control
1. Gear stage
1. Gear stage
2. Gear stage
3. Gear stage
4. Gear stage
5. Gear stage
Active parameter set
2 (Index=1)
2 (Index=1)
3 (Index=2)
4 (Index=3)
5 (Index=4)
6 (Index=5)
7.5 Closed-loop control
379