Dimensional Information For Transverse Axes - Siemens SINUMERIK 828D Function Manual

Hide thumbs Also See for SINUMERIK 828D:
Table of Contents

Advertisement

P1: Transverse axes

12.3 Dimensional information for transverse axes

12.3
Dimensional information for transverse axes
Transverse axes can be programmed with respect to both diameter and radius. Generally, they are diameter-
related, i.e. programmed with doubled path dimension so that the corresponding dimensional information can be
transferred to the part program directly from the technical drawings.
Figure 12-2
Transverse axis with diameter information (D1, D2)
Switching the diameter programming on/off
Channel-specific diameter programming
The activating or deactivating of the diameter programming is done via the modally active parts program
statements of the G group 29:
DIAMON: Diameter programming ON
DIAMOF: Diameter programming OFF, in other words, radius programming ON
DIAM90: Diameter or radius programming depending on the reference mode:
-
Diameter programming ON in connection with absolute dimensioning G90
-
Radius programming ON in connection with incremental dimensioning G91
DIAMCYCOF: Radius programming for G90 and G91 ON , for the HMI, the last active G code of this group
remains active
Reference is made exclusively to the transverse axis of the channel.
Axis-specific diameter programming for several transverse axes in one channel
Note
The additionally specified axis must be activated via MD30460
$MA_BASE_FUNCTION_MASK with bit2=1.
The axis specified must be a known axis in the channel. Geometry, channel or machine axes
are permitted.
Programming is not permitted in synchronized actions.
The following axis-specific modal statements can be programmed several times in a parts program block:
830
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Basic Functions

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 840d sl

Table of Contents