Siemens SINUMERIK 828D Function Manual page 1179

①
Function activated by user with a positive edge of
Note: This is only possible when the
②
Positioning axis active
Signals
this case irrelevant and is therefore not shown.
③
The user stops spindle oscillation by resetting
④
The spindle stops and the
⑤
The user then resets
⑥
Stop
Reset of causes
⑦
Stop
is reset in the user program and
Positioning axis active
means that
⑧
Axis cannot be started
...the
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Positioning axis active
Position reached
and
Start
Spindle stationary
signal is set.
Stop .
Positioning axis active
to be reset.
Start
is again set, incorrectly, in the same PLC cycle. This
is not reset, but...
signal is set (error number 106).
Start
.
signal is reset!
Position reached
are signaled back,
Stop
and setting .
P4: PLC for SINUMERIK 828D
14.6 Function interface
is in
1179