Examples Of Block Search With Calculation - Siemens SINUMERIK 828D Function Manual

K1: Mode group, channel, program operation, reset response
9.7 Block search
9.7.5

Examples of block search with calculation

Selection
From the following examples, select the type of block search that corresponds to your task.
Type 4 block search with calculation at block end point
Example with automatic tool change after block search with active tool management:
1. Set machine data:
MD11450 $MN_ SEARCH_RUN_MODE to 1
MD11602 $MN_ASUP_START_MASK Bit 0 = 1 (ASUB Start from stopped state)
2. Select ASUB "BLOCK_SEARCH_END" from PLC via FB4.
Reference:
/FB1/ Function Manual, Basic Functions, Basic PLC Program (P3)
3. Load and select part program "WORKPIECE_1".
4. Search to block end point, block number N220.
5. HMI signals "Search target found".
6. NC Start for output of action blocks.
514
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Basic Functions