Block Search Type 5 Serupro - Siemens SINUMERIK 828D Function Manual

K1: Mode group, channel, program operation, reset response

9.8 Block search Type 5 SERUPRO

9.8 Block search Type 5 SERUPRO
SERUPRO
The "search via program test" is from now on referred to as SERUPRO. This acronym has been derived from
"SEarch RUn by PROgram test".
Function
SERUPRO can be used for a cross-channel block search.
This search permits a block search with calculation of all necessary data from the previous history, so as to
acquire all previously valid status data for a particular overall NC status. The PLC is hereby updated to the
current status.
The NC is operated in "Program test" mode during this block search so that interactions between a channel and
synchronized actions or between several channels, can take place within an NCU.
Channels
In combination with the HMI, SERUPRO is provided for the following channels:
• For the current SERUPRO channel only (1)
• For all channels with the same workpiece name as the SERUPRO channel (2)
• For all channels with the same mode group as the SERUPRO channel (3)
• For all channels of the NCU (4)
The scope of channels for SERUPRO is selected by means of configuration file maschine.ini, in Section
[BlockSearch]:
Section [BlockSearch]
SeruproEnabled=1
SeruproConfig=1
All other channels started with SERUPRO are operated in "Self­Acting SERUPRO" mode. Only the channel in
which a target block has been selected can be started with a block search in SERUPRO mode.
518
Enable search function for HMI and select search configuration
;SERUPRO softkey available for HMI. Default value is (1)
;Number (1) to (4) of above indicated channel grouping. Default value is (1)
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Basic Functions