Siemens SINUMERIK 828D Function Manual page 898

P3: Basic PLC Program for SINUMERIK 840D sl
13.8 Structure and functions of the basic program
Relevant parameters (FB 1)
MCP-device identification
IdentMcpStrobe
IdentMcpBusProfilNo
MCP, BHG, HT8, HT2
Direct control keys, such as OP08T, OP12T
IdentMcpType (Mcp-Type)
no device connected
MCP 483C IE (Compact)
MCP 483C IE
MCP 310
MCP OEM
MCP DMG
HT8
TCU_DT (Direct control keys)
MCP_MPP
HT2
OP08T (direct control keys)
840D sl: PROFIBUS connection on the DP port
In case of PROFIBUS connection of the MCP, this component must be considered in the hardware configuration
setting of STEP 7. The MCP is connected to the standard DP bus of the PLC (not to MPI/DP). The addresses
must be stored in the input and output log range. These start addresses must also be stored in the pointer
parameters of the FB1. The FB1 parameters listed below are used for further parameterization.
There is no PROFIBUS variant of the HHU. For this reason, an Ethernet connection is shown for the HHU in this
figure. The Profibus slave address must be stored in the parameter "MCP1BusAdr" and "MCP2BusAdr". Enter
the pointer to the configured diagnostic address (e.g. P#A8190.0) in "MCPxStatRec".
898
Input parameters e.g. OP08T
Value
B#16#0
B#16#1
0
B#16#80
B#16#81
B#16#82
B#16#83
B#16#84
B#16#85
B#16#86
B#16#87
B#16#88
B#16#89
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Basic Functions