Reference Point Appraoch From Part Program (G74) - Siemens SINUMERIK 828D Function Manual

15.4

Reference point appraoch from part program (G74)

Referencing of machine axes can be activated for the first time or repeated from the part program
Referencing must be repeated, for example, after:
• converting the actual value of the machine axis: PRESETON function
• Machine axis is parked:
DB31, ... DBX1.5 (position measuring system 1) = 0
DB31, ... DBX1.6 (position measuring system 2) = 0
• DB31, ... DBX2.1 (servo enable) = 0
• Exceeding the encoder limit frequency of the position measuring system
Programming
Syntax
Machine axis Machine axis
{
G74
Function
Machine axes can be referenced from a part program with part program instruction G74
Machine axes
Parameter:
The name of the machine axis must be specified. The machine axis must be a channel axis of the channel in
which the part program is processed.
Effective:
G74 is non-modal.
Special features
G74 must be programmed in a separate part program block.
Reset response
Mode group reset or channel reset aborts the reference point approach for all programmed machine axes:
DB11, ... DBX0.7 (mode group reset)
DB21, ... DBX7.7 (channel reset)
All machine axes for which the reference point approach is not yet successfully completed when the action is
cancelled remain in status "Not referenced":
DB31, ... DBX60.4 (referenced / synchronized 1)
DB31, ... DBX60.5 (referenced / synchronized 2)
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
15.4 Reference point appraoch from part program (G74)
}
R1: Reference point approach
1205