Siemens SINUMERIK 828D Function Manual page 845

PI services
Tool management
Star/delta switchover
m:n
Safety Integrated
Program diagnostics
Mode switch for the PLC CPU
On the NCU module, the rotary switch labeled "PLC" is used to set the PLC operating modes.
The switch settings S are listed in the following table:
S Meaning Remark
0 RUN-P The PLC program can be changed without activation of the password
1 RUN Only read access operations are possible using a programming device (PG). It
is not possible to make changes to the PLC program until the password has
been set.
2 STOP Processing the PLC program is stopped and all PLC outputs are set to
substitute values.
3 MRES The PLC is switched into the STOP state followed by a PLC general reset
(default data).
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
P3: Basic PLC Program for SINUMERIK 840D sl
13.2 Key data of the PLC-CPUs for 840D sl and 840Di sl
Type of control
+ +
+ +
+ +
+ +
- +
+ +
845