Traversing Ranges - Siemens SINUMERIK 828D Function Manual

G2: Velocities, setpoint / actual value systems, closed-loop control
7.2 Velocities, traversing ranges, accuracies
7.2.2

Traversing ranges

Range of values of the traversing ranges
The range of values of the traversing range depends on the computational resolution selected.
If machine data:
MD10200 $MN_INT_INCR_PER_MM
(computational resolution for linear positions) (1000 incr./mm)
or
MD10210 $MN_INT_INCR_PER_DEG
(computational resolution for angular positions) (1000 incr./degree)
are assigned their default values, the following range of values can be programmed with the input resolution:
Table 7-1 Traversing ranges of axes
Linear axes X, Y, Z, etc.
Rotary axes A, B, C, etc.
Interpolation parameters I, J, K
The unit of measurement of rotary axes is always degrees.
If the computational resolution is increased/decreased by a factor of 10, the ranges of values change
accordingly.
The traversing range can be limited by software limit switches and working areas.
References:
/FB1/Function Manual, Basic Functions; Axis Monitoring, Protection Zones (A3)
The traversing range for rotary axes can be limited via machine data.
References:
/FB2/Function Manual, Extended Functions; Rotary Axes (R2)
For special features of linear and rotary axes with a large traversing range, see:
References:
/FB1/ Function Manual, Basic Functions; Reference Point Approach (R1)
332
G71 [mm, degrees]
Range
∓ 999.999,999
∓ 999.999,999
∓ 999.999,999
G70 [inch, degrees]
Range
∓ 399.999,999
∓ 999.999,999
∓ 399.999,999
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Basic Functions