Responses To Operator Or Program Actions - Siemens SINUMERIK 828D Function Manual

M02/M30 in a block
M00/M01 in a block
IS "Single block"
IS "Delete distance­to­go"
Auxiliary functions output to PLC but
not yet acknowledged
Wait instruction in program
9.9.7

Responses to operator or program actions

Status transitions
The following table shows the channel and program statuses that result after certain operator and program
actions.
The left-hand side of the table shows the channel and program statuses and the mode groups from which the
initial situation can be selected. Various operator/program actions are listed on the right­hand side of the table,
the number of the situation after the action has been carried out is shown in brackets after each action.
Table 9-7 Responses to operator or program actions
Channel
Situation
status
R V A
1 x
2 x
3 x
4 x
5 x
6 x
7 x
8 x
9 x
10 x
11 x
12 x
13 x
14 x
15 x
16 x
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
X
Program status
N V S W A
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
K1: Mode group, channel, program operation, reset response
Operator or program action (Situation after the
Active mode
action)
A M J
x RESET (4)
x RESET (5)
x RESET (6)
x NC Start (13); Mode change (5 or 6)
x NC Start (14); Mode change (4 or 6)
x Direction key (15); Mode change (4 or 5)
x NC Start (14)
x NC Start (15)
x NC Start (13); Mode change (10 or 11)
x NC Start (16); Mode change (9 or 11)
x Direction key (17); Mode change (9 or 10)
x NC Start (13); Mode change (10 or 11)
x NC Stop (12)
x NC Stop (7); at block end (5)
x NC Stop (8); at JOG end (6)
x NC Stop (10); at block end (10)
9.9 Program operation mode
X
X
X
X
X
567