Behavior In The Event Of A Conflict - Siemens SINUMERIK 828D Function Manual

9.15.2.6

Behavior in the event of a conflict

Conflict case
A conflict is present if several functions are programmed in one block and the functions should be replaced with
different subprograms:
• Addresses D and DL replaced with subprogram:
MD11717 $MN_FCT_CYCLE_NAME = "D_SUB_PROG"
• Address T replaced with subprogram:
MD10717 $MN_FCT_CYCLE_NAME = "T_SUB_PROG"
• M function M6 replaced with subprogram:
MD10715 $MN_M_NO_FCT_CYCLE[0] = 6
MD10716 $MN_M_NO_FCT_CYCLE_NAME[0] = "M6_SUB_PROG"
MD10718 $MN_M_NO_FCT_CYCLE_PAR = 0
MD22550 $MC_TOOL_CHANGE_MODE = 1
MD22560 $MC_TOOL_CHANGE_M_CODE = 6
Resolution
A conflict is resolved corresponding to the following table:
The following are programmed in one program line:
D and/or DL
–
–
–
x
x
x
x
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
T or TCA M6
– x
x –
x x
– –
– x
x –
x x
K1: Mode group, channel, program operation, reset response
9.15 Replacing functions by subprograms
Called subprogram:
M6_SUB_PROG
T_SUB_PROG
M6_SUB_PROG
D_SUB_PROG
M6_SUB_PROG
T_SUB_PROG
M6_SUB_PROG
647