Siemens SINUMERIK 802D sl Programming And Operating Manual page 92

Part programming
7.3 Editing part programs or text files
Use this softkey to delete a selected text (alternatively: <XTRL+X>)
Use the <Find> softkey to search for a string in the program file displayed.
Type the term you are looking for in the input line and use the <OK> softkey to start the
search. Use <Abort> to close the dialog box without starting the search process.
Use this softkey to replace the block numbers from the current cursor position up to the
program end.
See Chapter "Free contour programming (Page 93)"
See section titled "Cycles" (Page 163)
With the "Recompile" function you can:
● "Recompile" a cycle call
● "Recompiling" a "Free contour" programmed using the "Contour" function
92
To recompile a cycle call, the cursor must be positioned at the cycle calling line in the
program.
Using the "Recompile" function, for a cycle that was parameterized using a softkey
function, the cycle screen form is called again. This function decodes the cycle name and
prepares the screenform with the relevant parameters. If there are any parameters
beyond the range of validity, the function will automatically use the default values. After
closing the screen form, the original parameter block is replaced by the corrected block.
The contour that was parameterized using the "Contour" softkey function is called again
using the "Recompile" function.
In this case, position the editor cursor in a command line of the contour program.
This function decodes the parameterized contour and prepares the screen form with the
relevant parameters.
When recompiling, only the contour elements that were generated using the "Contour"
function are created again. In addition, only the texts that were added using the "Free text
input" input field are recompiled. Any changes you made directly in the program text are
lost. However, you can subsequently insert and edit user-defined texts, which will not be
lost.
Note
Only automatically generated blocks can be recompiled.
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Surface grinding