Siemens SINUMERIK 802D sl Programming And Operating Manual page 138

System
8.4 SYSTEM - "Service display"
Table 8- 6
N20 MSG ("FILE: Roughing the contour")
Note
If MSG commands follow one another, then a dwell time must be programmed between the
commands.
e.g.
N10 ...
N20 MSG("<interface>:sample text1")
N30 G4 F2.5
N40 MSG("<interface>:sample text2")
N50 G4 F2.5
N60 MSG("<interface>:sample text3")
N70 G4 F2.5
N80 MSG("<interface>:sample text4")
N90 ...
Note
If, in the part program, the text for the messages is repeated unchanged, then after each
output, a command for an empty text must be entered.
e.g.
N10 ...
N20 MSG("<interface>: sample text")
N30 MSG("<interface>:")
...
...
N100 MSG("<interface>:sample text")
N110 MSG("<interface>:")
...
...
N200 MSG("<interface>:sample text")
N210 MSG("<interface>:")
...
138
Messages to the output interface file
; The text "Roughing the contour" is
sent to the selected file
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Surface grinding