Siemens SINUMERIK 802D sl Programming And Operating Manual page 43

Press the <Calculate position> softkey to calculate the setpoint.
Note
This procedure must be done for each axis separately.
Exit the "Register workpiece" function.
Special features in connection with manual grinding
If you have interrupted manual grinding (Page 45) with the PLC key "Handwheel" during
manual grinding, then the last position of the infeed axis can be calculated following
"Measure workpiece" > "Calculate position".
Above the HMI, the following text appears:
"Accept setting value from manual grinding - continue with NC start".
Figure 4-15
Measuring is possible only for the infeed axis from manual grinding and only once directly
after manual grinding. If "Measure workpiece" is aborted or another axis is set as the last
infeed axis, then every axis with any axis positions must be calibrated again.
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Measure workpiece after manual grinding
Setup
4.4 Sense workpiece
43