Siemens SINUMERIK 802D sl Programming And Operating Manual page 58

Manual mode
5.2 JOG mode - "Position" operating area
Note
If a second spindle is integrated into the system, the workspindle will be displayed using a
smaller font. The window will always display the data of only one spindle.
The control system displays the spindle data according to the following aspects:
The master spindle (large display) is displayed:
- Idle,
- at spindle start
- with both spindles active
The workspindle (small display) is displayed:
- when starting the workspindle
The power bar applies to the spindle currently active. With both master spindle and
workspindle active, the master spindle performance bar is displayed.
Softkeys
Note
The vertical softkeys are explained in the the section titled MDA mode (Page 60).
This function is for grinding (precision grinding) with the handwheel. This function does not
require a workpiece program.
This function is used to determine the dresser positions in the machine for dressers that are
used by means of the geometry axes.
This function is used to detect the workpiece position in the machine with respect to the
particular axis.
This function is used to shape a "raw" grinding wheel without generating an NC program.
Note
The parameters within the "Settings" function do not affect grinding.
Use this softkey to switch between the metric and the inch dimension systems
58
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Surface grinding