Siemens SINUMERIK 802D sl Programming And Operating Manual page 70

Automatic mode
6.1 Automatic mode
This window displays the auxiliary and M functions currently active.
Selecting the softkey repeatedly will close the window.
All the G functions are displayed.
Use this softkey to display the "Axis feedrate" window.
Pressing the softkey repeatedly will close the window.
Use this softkey to switch from the seven-block to the three-block display.
Switches the axis value display between the machine, workpiece and relative coordinate
systems.
Use this softkey to display the "Machining offset" window.
Fine offsets can be entered in Y and Z, globally for each seat or individually for a specific
seat.
From then on, these offsets will always be used for the grinding work (seat).
Use this softkey to close the screen. Your offsets are saved.
The program control softkeys are displayed (e.g. "Skip block", "Program test").
● "Skip" (SKP): Program blocks that are identified with a slash in front of the block number
● "Dry run feedrate" (DRY): If you select this softkey, all traversing motions will be
● "ROV effective" (ROV): The feedrate override switch will also act on the rapid traverse
● "Conditional stop" (M01): When this function is active, processing of the program is
● "Program Test" (PRT): If "Program test" is selected, the output of setpoints to axes and
● "Single block, fine": If this function is active, the part program blocks are executed as
70
are skipped when the program starts (e.g. "/N100").
performed with the feedrate setpoint specified via the "Dry run feed" setting data. Instead
of the programmed motion commands, the dry run feedrate is active.
override.
stopped at every block in which miscellaneous function M01 is programmed.
spindles is disabled. The set point display "simulates" the traverse movements.
follows: Each block is decoded separately, and a stop is performed at each block; an
exception are only the thread blocks without dry run feedrate. In such blocks, a stop is
only performed at the end of the current thread block. Single Block fine can only be
selected in the RESET state.
Note
Single block (SBL) can be activated using the <SINGLE BLOCK> machine control panel
key.
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Surface grinding