Stop / Cancel A Part Program; Reapproach After Cancellation - Siemens SINUMERIK 802D sl Programming And Operating Manual

Automatic mode

6.6 Stop / cancel a part program

6.6 Stop / cancel a part program
Operating sequence
With <NC STOP> the execution of a part program is interrupted.
The interrupted machining can be continued with <NC START>.
Use <RESET> to abort the program currently running.
By pressing <NC START> once again, the aborted program is restarted and executed from
the beginning.
6.7

Reapproach after cancellation

After a program cancellation (RESET), you can retract the tool from the contour in manual
mode (JOG).
Operating sequence
Select mode <AUTOMATIC> mode.
Opening the "Block search" window for loading the interruption point.
The interruption point is loaded.
The block search to the interruption point will start. An adjustment to the start position of the
interrupted block will be carried out.
Press <NC START> to continue machining.
80
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Surface grinding