Fonts - Siemens SINUMERIK 802D sl Programming And Operating Manual

10.1.5

Fonts

The following characters are used for programming; they are interpreted in accordance with
the relevant definitions.
Letters, digits
A, B, C, D, E, F, G, H, I, J, K, L, M, N, O, P, Q, R, S, T, U, V, W X, Y, Z
0, 1, 2, 3, 4, 5, 6, 7, 8, 9
No distinction is made between upper and lower case letters.
Printable special characters
(
)
[
]
<
>
:
=
/
*
+
-
Non-printable special characters
L : End-of-block character
F
Blank: Separator between words; blank
Tabulator: Reserved; do not use
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Open parenthesis
Close parenthesis
Open square bracket
Close square bracket
less than
greater than
Main block, end of label
Assignment, part of equation
Division, block suppression
Multiplication
Addition and positive sign
Subtraction, minus sign
10.1 Fundamental principles of NC programming
" Inverted commas
_ Underscore (belongs to letters)
. Decimal point
, Comma, separator
; Comment start
% Reserved; do not use
& Reserved; do not use
' Reserved; do not use
$ System variable identifiers
? Reserved; do not use
! Reserved; do not use
Programming
197