Siemens SINUMERIK 802D sl Programming And Operating Manual page 50

Setup
4.7 Program setting data
● Dry run feed (DRY)
● Starting angle for thread (SF)
Place the cursor bar on the input field to be modified and enter the value.
Either press the <Input> key or move the cursor to confirm.
Softkeys
The working area limitation is active with geometry and additional axes. If you want to use a
working area limitation, its values can be entered in this dialog box. Selecting the "Set active"
softkey enables/disables the values for the axis highlighted by the cursor.
Figure 4-24
50
The feedrate which can be entered here will be used instead of the programmed feedrate
in the AUTOMATIC mode if the "Dry run feed" function is selected.
For thread cutting, a start position for the spindle is displayed as the start angle. A
multiple thread can be cut by changing the angle when the thread cutting operation is
repeated.
Working area limitation
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Surface grinding