Siemens SINUMERIK 802D sl Programming And Operating Manual page 51

Times Counters
Figure 4-25
Meaning:
● Total parts: Total number of workpieces produced (total actual)
● Parts requested: Number of workpieces required (workpiece setpoint)
● Number of parts: This counter registers the number of all workpieces produced since the
● Total runtime: Total runtime of NC programs in AUTOMATIC mode
● Program runtime Active tool operating times
● Feedrate runtime
The timer is automatically reset to zero in the case of a "Control power-up with default
values".
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Times, Counters
starting time.
Note
The counter functionality is set using the following channel-specific machine data:
• MD27880 $MC_PART_COUNTER, the workpiece counter is activated
• MD27882 $MC_PART_COUNTER_MCODE[0-2], workpiece counting with user
defined M command
In the AUTOMATIC mode, the runtimes of all programs between NC START and end of
program / RESET are summed up. The timer is zeroed with each power-up of the control
system.
The runtime between NC Start and End of program / Reset is measured in the selected
NC program. The timer is reset with the start of a new NC program.
The runtime of the path axes is measured in all NC programs between NC START and
end of program / RESET without rapid traverse active and with the tool active. The
measurement is interrupted when a dwell time is active.
Setup
4.7 Program setting data
51