Siemens SINUMERIK 802D sl Programming And Operating Manual page 127

The parameters for the measuring time and for the trigger type for channel 1 can be set in
the lower screen half. The remaining channels will accept this setting.
● Determining the measuring period: The measuring period in ms is entered directly into
● Selecting the trigger condition: Position the cursor on the "Trigger condition" field and
The "V mark ON" / "V mark OFF"softkeys are used to hide/show the vertical gridlines. Using
the "Select signal" function you can determine the signal to be displayed in the vertical axis.
The "T mark ON" / "T mark OFF"softkeys are used to hide/show the horizontal gridlines of
the time axis.
Use the markers to determine the differences in the horizontal or vertical directions. To do
this, place the marker on the start point and press "Fix V mark" or "Fix T mark". The
difference between the starting point and the current marker position is now displayed in the
status bar. The softkey labels will change to "Free V mark" or "Free T mark".
This function opens another menu level offering softkeys for hiding / displaying the diagrams.
If a softkey is displayed on a black background, the diagrams are displayed for the selected
trace channel.
Use this function to zoom in / zoom out the time basis.
Use this function to increase / reduce the resolution (amplitude).
Use these softkeys to define the step sizes of the markers.
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
the "Measuring period" input field (6,133 ms max.).
select the relevant condition using the toggle key.
– No trigger, i.e. the measurement starts directly after selecting the "Start" softkey;
– Positive edge;
– Negative edge
– Exact stop fine reached;
– Exact stop coarse reached
8.4 SYSTEM - "Service display"
System
127