Installing Applications; Activating/Deactivating Application Use; Deleting Applications; Restarting The System - Kyocera TASKalfa 420i Service Manual

2KR/2KS
(12) Applications

Installing Applications

1. Insert the USB memory containing the application
to be installed into the USB memory slot (A1).
2. Press [Add].
3. Select the application to be installed and press
[Install].
You can view detailed information on the selected
application by pressing [Detail].
4. When the confirmation screen appears, press
[Yes].
Installation of the application begins. Depending on
the application being installed, the installation may
take some time. Once the installation ends, the
original screen reappears.
5. To install another application, repeat steps 3 to 4.
6. To remove the USB memory, press [Remove Mem-
ory] and wait until the Removable Memory can be
safely removed message appears. Then remove
the USB memory.

Activating/Deactivating Application Use

1. Select the desired application and press [Activate].
You can view detailed information on the selected
application by pressing [Detail].
2. Enter the license key and press [Official]. Some
applications do not require you to enter an license
key. If the license key entry screen does not
appear, go to Step 3.
To use the application as a trial, press [Trial] without
entering the license key.
3. When the confirmation screen appears, press
[Yes].

Deleting Applications

1. Select the application to be deleted and press
[Delete].
You can view detailed information on the selected
application by pressing [Detail].
2. When the deletion confirmation screen appears,
press [Yes]. The application is deleted.
1-3-116
(13) System Settings

Restarting the System

1. Press [Execute] of Restart.
2. When the confirmation screen appears, press
[Yes]. The system is restarted.
Network Setup
TCP/IP (IPv4) Setup
1. Press [Next] of Network and then [Next] of TCP/IP
Setting.
2. Press [Change] of TCP/IP.
3. Press [On] and then press [OK].
4. Press [Change] of IPv4.
5. Press [DHCP].
6. Press [Off] of DHCP and then press [OK].
7. Press [Bonjour].
8. Press [Off] of Bonjour and then press [OK].
9. Press [IP Address] and enter the address using the
numeric keys.
10. Press [Subnet Mask] and enter the address using
the numeric keys.
11. Press [Default Gateway] and enter the address
using the numeric keys.
12. Check if all the address entries are correct and
press [OK].
13. After changing the setting, restart the system or
turn the machine OFF and then ON again.
TCP/IP (IPv6) Setup
1. Press [Next] of Network and then [Next] of TCP/IP
Setting.
2. Press [Change] of TCP/IP.
3. Press [On] and then press [OK].
4. Press [Next] of IPv6.
5. Press [Change] of IPv6.
6. Press [On].
7. Press [OK].
8. After changing the setting, restart the system or
turn the machine OFF and then ON again.
Manual Setting (IPv6)
1. Press [Next] of Network and then [Next] of TCP/IP
Setting.
2. Press [Next] of IPv6.
3. Press [Next] of Manual Setting.
4. Press [IP Address (Manual)] to enter IP address.
5. Press [OK].
Press [# Keys] of Prefix Length (0 - 128) to enter
the prefix length using the numeric keys.
6. Press [Default Gateway] to enter the default gate-
way.
7. Check that all the entries are correct and Press
[OK].
8. After changing the setting, restart the system or
turn the machine OFF and then ON again.