Kyocera TASKalfa 420i Service Manual page 166

2KR/2KS-2
Section Description
Finisher 80
Jam between the fin-
isher and machine
81
Paper entry sensor non
arrival jam
82
Jam in stapler
83
Eject sensor stay jam
1-4-8
Conditions
Paper ejection is not output from the machine to the docu-
ment finisher within specified time of the paper entry sensor
(PES) turning on.
(3000-sheet document finisher)
The paper entry sensor (PES) is not turned off even if a
specified time has elapsed after the machine eject signal
was received.
(3000-sheet document finisher)
The paper entry sensor (PES) is not turned on even if a
specified time has elapsed after the machine eject signal
was received.
(3000-sheet document finisher)
The paper entry sensor (PES) does not turn off within spec-
ified time of its turning on.
(Document finisher)
The paper entry sensor (PES) is not turned on even if a
specified time has elapsed after the machine eject signal
was received.
(Built-in finisher)
The paper conveying switch (PCSW) is not turned on even
if a specified time has elapsed after the machine eject sig-
nal was received.
(Built-in finisher)
The paper conveying switch (PCSW) does not turn off
within specified time of its turning on when paper is con-
veyed to the intermediate tray from the paper conveying
unit.
(3000-sheet document finisher)
The home position is not detected within the specified time
when driving the staple motor.
(Document finisher)
The staple home position sensor (STSPS) is not turned on
within the specified time when driving the staple motor
(STM).
(Built-in finisher)
The staple home position sensor (STHPS) is not turned on
within the specified time when driving the staple motor
(STM).
(3000-sheet document finisher)
Eject switch 1 (ESW1) is not turned off within specified time
of its turning on.
(Document finisher)
In the straight mode, the exit sensor (EPS) is not turned off
within specified time of its turning on.
(Document finisher)
In the bundle discharge mode or the staple mode, bundle
discharge operation does not turn off within specified time
since the operation starts.
(Built-in finisher)
The paper conveying switch (PCSW) does not turn off
within specified time of its turning on when paper is ejected
to the finisher tray from the intermediate tray.
Specified time
15 s
1052 ms
1052 ms
2313 ms
733 ms
1217 ms
Paper length +
869 ms
600 ms
-
600 ms
1182 ms
-
902 ms
Paper length +
869 ms