Removing The Paper Feed Pulley; Removing The Separation Pulley - Kyocera TASKalfa 420i Service Manual

2KR/2KS

Removing the paper feed pulley

7. Remove two stop rings from the primary
paper feed unit.
8. Pull the paper feed pulley shaft in the direc-
tion of the arrow and remove the paper feed
pulley.

Removing the separation pulley

9. Remove the stop ring from the primary
paper feed unit.
10. Pull the separation pulley shaft in the direc-
tion of the arrow and remove the separation
pulley.
11. Replace the forwarding, paper feed and
separation pulleys.
12. Install the separation and paper feed pulleys
to the primary paper feed unit.
13. Install the forwarding pulley to the forward-
ing pulley retainer.
When refitting the forwarding pulley, orient it
correctly as shown in Figure 1-5-8.
14. Refit the forwarding pulley retainer to the pri-
mary paper feed unit.
15. Refit the primary paper feed unit.
16. When the forwarding pulley, paper feed pul-
ley, separation pulley or the primary paper
feed unit is replaced, perform maintenance
mode U901 to clear the counter value (see
page 1-3-96).
1-5-4
Stop ring
Paper feed
pulley shaft
Paper feed pulley
Figure 1-5-6
Separation pulley shaft
Stop ring
Figure 1-5-7
Machine front
Forwarding pulley
Figure 1-5-8
Stop ring
Separation pulley
Machine rear