TGW4/8 Gateway Series for Aeonix
2.3.4 System Configuration
After login, click the Basic > System tab to open the System configuration interface.
System Configuration Interface
Figure 2-11
System Configuration Parameters
Table 2-5
Note: * indicates mandatory parameters for Aeonix.
Name
First digit timer
Interdigit timer
Complete entry
timer
*
Codec
Tadiran Telecom (TTL) L.P.
Description
If a subscriber does not dial any digit within the specified time by this parameter after
off-hook, the gateways will prompt to hang up with a busy tone.
The value must be an integer, and decimal points are not allowed.
Unit: Seconds; Default value: 15 sec.
The maximum time interval to dial the next digit.
After timeout, the gateways will call out with the collected number.
The value must be an integer, and decimal points are not allowed.
Unit: Seconds; Default value: 5 sec.
The value must be an integer, and decimal points are not allowed.
Unit: second; Default value: 2 sec.
This parameter is used with the "x.T" rule set in dialing rules. For example, there is
"021.T" in the dialing rules table. When a subscriber has dialed 021 and has not dialed
the next number within a set time by this parameter (eg. 2 sec), the gateways will
consider that the subscriber has ended dial-up and call out the dialed number 021.
Codecs supported by the deivce include G729A/20, PCMU/20 and PCMA/20. This
parameter must be set due to no default value. For details, see Table 2-6.
Several encoding methods can be configured in this item at the same time, separated
with "," in the middle; the gateways will negotiate with the platform in the order from
front to back when configuring the codec methods.
For Aeonix Enter the required codecs methods to be supported by the gateway.
These codecs must be set due to no default value.
Insert G729 PCMA & PCMU as first codecs.
User Configuration Manual
17