Mcc Configuration Ports Screens (Reserved For Future Use); Mcc Configuration Interfaces Screens - Paradyne 8540 User Manual

MCC Configuration Ports Screens
(Reserved for Future Use)

MCC Configuration Interfaces Screens

8000-A2-GB20-20
NOTE:
There are no configurable ports on the MCC at this time.
Use the system information submenu of the Interfaces screens to configure basic
interface information.
Procedure
To configure general interfaces, IP networks, and control interfaces:
1. Follow this menu sequence:
Configuration
2. The Interfaces menu appears. Enter the desired value on each selected
screen and field as shown in Table 5-2 and press Return.
Table 5-2. Interfaces Menu Options (1 of 2)
General (Interfaces)
Gives the user the ability to configure basic information about a given interface.
Interface Name – s1b = backplane that connects all the cards, e1a = Ethernet port.
Type – Static.
Protocol – Type of protocol for an interface.
Port List – Name of the port associated with this interface.
MTU (max) (Maximum Transmission Unit) – 64–64000 (Default = 1500). For the
Model 8540, the MTU (max) is 1500, with the range being 61–1500.
NOTE: The above MTU values are the only values you may enter. Do not change
the MTU of s1b from the default of 1500. Make certain that if you change
from the default value, the numbers are appropriate to your network. Do a
card reset or reset the interface.
November 1997
Interfaces (A-C)
MCC Card Configuration
A-C-A
5-5