Management System Source Validation For Dsl Cards; Dsl Snmp Community Strings And Authentication Failure Trap; Enable Dsl Port Traps; Enable/Disable Endpoint Security To 5446 Rtu - Paradyne 8540 User Manual

Checklist for Setting Up SNMP Features

Management System Source Validation for DSL cards

DSL SNMP Community Strings and Authentication Failure Trap

Enable DSL Port Traps

Enable/Disable Endpoint Security to 5446 RTU

B-2
From the DSL Main Menu, select Configuration
Enable IP address security validation.
Enter the IP addresses of up to five NMS managers that will permitted access
to this DSL card.
Each card does not have to have the same set of managers as any other
card or as the MCC.
Enter access permission to be granted each NMS system
(ReadOnly(ro)/Read/Write(rw)/NoAccess(na)).
From the DSL Main Menu, select Configuration
(A-F-C).
Enter Read Only community string name(s).
Enter Read/Write community string name(s).
If desired, enable the Authentication Failure trap.
From the DSL Main Menu, select Configuration
Select a DSL port.
If desired, enter a value for the Margin Threshold.
If desired, enter a value for the Link Down Count Threshold.
If desired, enter a value for the Error Rate (minute) Threshold.
If desired, enter a value for the Error Rate (hour) Threshold.
Reset the port (A-C-C).
From the DSL Main Menu, select Configuration
Select an endpoint cookie.
Enable/Disable endpoint security for the specified port.
November 1997
SNMP Security (A-F-A).
SNMP Communities/Traps
Ports DSL Ports (A-B-B).
SNMP Security (A-F-A).
8000-A2-GB20-20