Paradyne 8540 User Manual page 20

HotWire Menus and Screens
2-4
2. Display Area is the top portion of the screen on which pertinent DSLAM
system information is displayed. This is also the portion of the screen on
which fields requiring input are displayed. However, you cannot enter values
for the fields in this portion of the screen. You must enter field values in the
Input Line at the bottom of the screen (see below).
3. Input Line is the area of the screen where you are prompted to enter values
for the specific field that is highlighted on the screen.
For example, in the Configure DSL IP Addr screen above, the DSL Card
Subnet Mask field is highlighted. If you want to change the subnet mask, you
must enter the new subnet mask at the (nnn.nnn.nnn.nnn): prompt at
the bottom of the screen.
4. Status Line is the last line on the screen. This line displays status
information about the selected card.
For example, in the above illustration, the following line is displayed:
HotWire 8800: MCC: 8000: __ __ __ X
The first field indicates the chassis type. In this case, the system in use is the
HotWire 8800 DSLAM system. The second field indicates the card selected.
In this example, the MCC card is selected. The remaining fields indicate card
status information, such as whether or not an alarm is present and the status
of the Ethernet link. Similar information is displayed on the Card Selection
screen. For information about these fields, see
page 2-14.
November 1997
Card Selection Screen on
8000-A2-GB20-20