Resetting the MCC Card
Selecting a DSL Card to Configure
8000-A2-GB20-20
After configuring the MCC card, reset the MCC card to install the configuration
settings.
Procedure
To reset the HotWire Chassis:
1. Select Configuration
2. Enter yes (y) to verify MCC reset.
NOTE:
When you enter yes, all data connectivity is interrupted.
3. Wait for the MCC card to reboot.
4. Press Return.
5. The Operator Login screen is displayed.
6. Enter login information.
All DSL cards that are present in the chassis and have had backplane addresses
assigned to them should appear on the Card Status screen. However, if one or
more do not appear, go to the MCC card, select Configuration
Cards Reset Slot and reset the DSL card.
Procedure
To select a specific DSL card to configure:
1. From the HotWire Chassis Main Menu, select Card Selection (B).
2. Enter DSL nn or nn , where nn is the number of the DSL card you want to
configure, and press Return.
The HotWire DSL menu is displayed.
3. Select Configuration and press Return.
The Configuration Menu is displayed.
November 1997
Configuring the HotWire DSLAM
Card Status Card Reset (A-A-F).
DSL
4-11