System Does Not Recognize New Dsl Cards; Large Number Of Traps; Cannot Communicate With Interface - Paradyne 8540 User Manual

Diagnostics and Troubleshooting

System Does Not Recognize New DSL Cards

Large Number of TRAPS

Cannot Communicate with Interface

8-14
PROBLEM: System does not recognize new DSL cards with new
addresses (Addresses not pre-configured on MCC card).
ACTION: 1. Configure new DSL cards from MCC screen.
2. Restart s1b interface (see Configuration
(A-G) in
3. Reset DSL card from the MCC screen (see Configuration
DSL Cards (A-G) in
4. Pull the card out and push it back in.
PROBLEM: DSL cards not using MCC Router ID as source address for
traps.
ACTION: 1. In standard configuration, MCC and DSL are in separate
subnets and Router ID is the same as IP Base Address of
MCC's LAN ( e1a ) interface. Set the Router ID to the
management IP address on MCC's LAN interface.
2. Set this as "Base IP Address" for LAN interface.
3. Reset MCC and all cards (see Configuration
(A-G) in
PROBLEM: Cannot communicate with Ethernet or other interface after
adding, changing, or deleting IP addresses on DSL or MCC
card.
ACTION: 1. When you add, change, or delete addresses on a DSL card,
you must restart that interface (see Configuration
Interfaces (A-C) in
November 1997
Chapter 6).
Chapter 6).
Chapter 4).
Chapter 6).
DSL Cards
DSL Cards
8000-A2-GB20-20