Assigning Ip Addresses To The Dsl Card Lan - Paradyne 8540 User Manual

Configuring the HotWire DSLAM

Assigning IP Addresses to the DSL Card LAN

4-14
Use this procedure to give DSL cards a LAN Interface IP address in each
Network Service Provider (NSP) domain supported by those cards.
Procedure
To assign IP addresses to the DSL Card LAN:
1. Select Configuration
2. Enter values for the following fields and press Return after each entry:
Field
IP Interface
IP Address (for
each 8540 and
8546 DSL card)
Subnet Mask
Route to Peer
(Field does not
appear on e1a and
Model 8540.)
* Enter the network/subnetwork portion of the Base IP address, with 0 for the
host portion so that the Peer is the entire subnet.
In addition, the following fields also appear on the screen. These fields can
be used to customize your application.
Field
Input Filter
Output Filter
3. Press Ctrl-z to return to the Configuration
November 1997
Interfaces IP Network (A-C-B).
Description
Name of the interface.
IP address for each DSL card
in the system. This address
must be different that the
management domain IP
address.
Associated subnet mask for
the specified destination IP
address.
Routing method used to get
to peer (i.e., host or net).
Description
Prevents packets from
entering the DSL card
through a specified interface.
Prevents packets from going
out of the DSL card through a
specified interface.
Interfaces menu.
Input
e1a (Ethernet port)
nnn.nnn.nnn.nnn format.
(Subnet is predetermined –
you can enter the host
number.)
nnn.nnn.nnn.nnn format
Net
Input
Blank to disable.
Blank to disable.
8000-A2-GB20-20