Paradyne 8540 User Manual page 144

Traps
8000-A2-GB20-20
Traps are configured via a Telnet or terminal session. The addition or removal of
a card or another hardware component within the HotWire DSLAM system
causes a trap to be generated. These traps indicate a configuration change
notification (CCN) of a card (a hardware replacement or a software upgrade).
The DSL card sends the following traps.
Event
Device failure
Self-test failure
CCN (Configuration
Change Notice)
Entity MIB CCN
(Configuration Change
Notice)
xDSL link up or down
Transitions threshold
exceeded
Authentication failure
Authentication failure
xDSL port speed low
xDSL port speed normal
November 1997
Trap Class Comment
major —
minor Sent if any portion of a restart/self test fails.
warning Configuration change caused by one the
following events:
software download
configuration download
card removed
warning Configuration changed caused by changes
affecting the entity MIB.
minor Number of link down events above
threshold. This rate is limited to once every
15 minutes.
minor SNMP community string.
minor Telnet passwords. This trap may be
overloaded for Telnet based auth failures. In
these cases, the following will also be sent
along with the trap PDU:
Access mode used
Number of Auth failures
warning Port speed decreased to lower bound thresh-
old setting.
normal Port speed now above lower bound.
E
E-1