Logging In To The System (After The System Has Been Configured) - Paradyne 8540 User Manual

HotWire Menus and Screens
Logging in to the System (After the System Has Been
Configured)
2-12
The following figure illustrates the complete Monitoring menu hierarchy from the
HotWire – DSL menu.
(A) Card/CPE Status
A. Card Info
B. Login History
C. Syslog
(B) Physical Layer
A. Active List
B. Ether Statistics
C. HDLC Bus Stats
D. DSL Link Perf
E. DSL Perf Stats
F. DSL Error Stats
G. DSL Xmit Stats
*Not on Model 8540
NOTE:
When you power on the system for the first time, the system displays the
Who Am I screen. This screen can be accessed only from the local console.
For information about this screen, see
Time
in Chapter 3.
This section describes how to log in to the HotWire DSLAM system after the
system has been configured for the first time.
November 1997
(C) Interfaces (E) IP Router
A. Active List A. Routing Table
B. Status B. ARP Table
C. Filter Table
(D) Network Protocol
A. Socket Statistics
B. UDP Statistics
C. TCP Statistics
D. IP Statistics
E. ICMP Statistics
F. SNMP Statistics
G. HDLC Statistics
H. PPP Stats*
(H) PPP Stats
A. General
B. LCP Stats
C. IPCP Stats
Accessing the System for the First
Monitoring
A. Card Status
B. Physical Layer
C. Interfaces
D. Network Protocol
E. IP Router
F. RTU Information
(F) RTU config
A. RTU Information
97-15565-01
8000-A2-GB20-20