Resetting the DSL Card
8000-A2-GB20-20
After configuring all of the service domain IP addresses on a DSL card (IP
address has been added or changed), reset the card to enable the new
configuration changes.
Procedure
To reset the DSL Card:
1. Select Configuration
2. Enter DSL nn , where nn is the slot number for the DSL card you just
configured.
3. Enter Y at the prompt to confirm.
NOTE:
When you enter Y, all data connectivity is interrupted.
4. If you have entered yes, verify that the LEDs on the DSL card go through
the reset sequence once, and then a second time after approximately
10 seconds (BOOTP).
November 1997
Configuring the HotWire DSLAM
Card Status
Card Reset (A-A-F).
4-15