Accessing The Hotwire - Mcc Menu - Paradyne 8540 User Manual

Accessing the HotWire – MCC Menu
8000-A2-GB20-20
Position Display
7 d3 (DSL)#
8 d4 (DSL)#
9 w1 (WAN)*#
– w2 (WAN)*#
– w3 (WAN)*#
– w4 (WAN)*#
* Not applicable for 8540 or 8546 DSLAM RADSL circuit cards of MCC cards.
# Not used for MCC cards.
If an option is not active, an underscore is shown in its place.
Also on this screen, there is a prompt used to select a specific card in the DSLAM
chassis. When a DSL slot number is entered, you are telneted (in the
background) to the card you selected.
NOTE:
When you select MCC on this screen, there is no telnet session involved. The
login screens and the top level menu reside on the MCC.
For more information about the status displayed on this screen, such as major
and minor alarms, see Troubleshooting
Procedure
To access the HotWire – MCC menu:
1. From the HotWire Chassis Main Menu, select B for Card Selection.
The Card Selection screen appears.
2. At the Goto Card (MCC or DSLnn): prompt, enter MCC or M.
The HotWire – MCC menu appears.
November 1997
HotWire Menus and Screens
Description
Status of DSL card Port 3 (U=UP, D=Down,
or X=Disabled, or H=Handshaking)
Status of DSL card Port 4 (U=UP, D=Down,
or X=Disabled, or H=Handshaking)
Status of WAN link (U=Up, D=Down,
L=Loopback)
Status of WAN link Port 2 (U=Up, D=Down,
L=Loopback)
Status of WAN link Port 3 (U=Up, D=Down,
L=Loopback)
Status of WAN link Port 4 (U=Up, D=Down,
L=Loopback)
in Chapter 8.
2-15