Configuring Mcc Cards, Dsl Cards, And Rtus - Paradyne 8540 User Manual

Configuring the HotWire DSLAM

Configuring MCC Cards, DSL Cards, and RTUs

4-2
Use the procedures in the following order to configure the MCC and DSL cards
for the basic setup for terminal management and user data connectivity.
NOTE:
It is assumed that you have read the HotWire DSLAM for 8540 and 8546 DSL
Cards Network Configuration Guide and have assigned service and
management domain IP addresses for all devices (MCC, DSL, and RTUs).
For your convenience, Appendix A of the Network Configuration Guide
contains worksheets to record your configuration settings.
The following tables list the basic steps you need to configure the MCC cards,
DSL cards, and RTUs.
For the Management Domain,
perform task . . .
1. Configure time and date.
2. Assign the IP address to the
backplane on the MCC card.
3. Assign the IP addresses to the
DSL cards.
4. Create SNMP Community
Strings and Authentication
Failure Trap.
5. Create default route.
6. Reset the MCC card.
7. Select a DSL card to configure.
8. Configure 5446 RTU IP host
address for the 8546 DSL card.
(Not applicable to 8540 DSL
card.)
November 1997
On the . . . See . . .
MCC Setting Time and Date
page 4-6.
Assigning IP Addresses to the
MCC
Backplane on the MCC
page 4-7.
MCC Assigning IP Addresses to the DSL
Cards on the MCC Card
page 4-8.
MCC Creating SNMP Community
Strings and Authentication Failure
Trap , page 4-9.
MCC Creating the Default Route
page 4-10.
MCC Resetting the MCC Card,
page 4-11.
DSL Selecting a DSL Card to
Configure , page 4-11.
Configuring 5446 RTU IP Host
DSL
Addresses on the 8546 DSL Card,
page 4-12.
Screen,
Card,
,
,
8000-A2-GB20-20