Configuring 5446 Rtu Ip Host Addresses On The 8546 Dsl Card - Paradyne 8540 User Manual

Configuring the HotWire DSLAM

Configuring 5446 RTU IP Host Addresses on the 8546 DSL Card

4-12
Use this procedure to assign an IP address within the management subnet to
each 5446 RTU interoperating with an 8546 DSL card.
Procedure
To configure IP host addresses on the DSL card:
1. Select Configuration
2. Enter values for the following basic fields and press Return after each entry:
Field
IP Interface
Peer IP Address
Route to Peer
* The subnet mask can be changed for the corresponding 5446 RTU. Refer to
Appendix F, 5446 RTU
NOTE:
The DSL interface is "unnumbered," meaning it requires no IP address.
(This field is read only.)
The following fields also appear on the screen. These fields can be used to
customize your application.
Field
Input Filter
Output Filter
3. Repeat the above procedure for interfaces s1d, s1e, and s1f (8546 DSL
Ports 2, 3, and 4, respectively).
4. Press Ctrl-z to return to the Configuration
November 1997
Interfaces IP Network (A-C-B) .
Description
Name of the interface.
IP address associated with
the other end of the link; i.e.,
the 5446 RTU.
Routing method to use to get
to peer (i.e., host or net).
Setup.
Description
Prevents packets from
entering the DSL card
through a specified interface.
Prevents packets from going
out of the DSL card through a
specified interface.
Interfaces menu.
Input
s1c (8546 DSL interface)
nnn.nnn.nnn.nnn format *
Host
Input
Blank to disable.
Blank to disable.
8000-A2-GB20-20