Lexmark Pro5500t Service Manual page 98

4447-20x
Symptom
Ink tank will not eject
No display
No network
No power
Second tray not detected
2-55
Service Manual
Technical Support Center:
Press the release tab. If the ink tank will not eject; then push the ink tank in and,
press the release tab again. If the ink tank will still not eject; then press the release
button while manually pulling the ink tank by holding the ink tank handle. If the
problem remains, then replace the printer.
Service:
Check for obvious damage on the ink tank. If there is none, then replace the tank
receiver assembly with inlet. See
on page 4-79.
Technical Support Center:
Check the following conditions:
• The electrical outlet is not damaged.
• The power cord and power supply are properly installed to the printer.
If the problem remains, then replace the printer.
Service:
Go to "No display service check" on page
Technical Support Center:
Turn off the printer by unplugging the power cord. Wait for 10 seconds, and turn on
the printer. Check the network cable connection for proper installation. Refer to the
User's Guide or visit the Lexmark Support Web Site at
on how to set up the printer on a network. If the problem remains, then replace the
printer.
Service:
Go to "No network service check" on page
Technical Support Center:
Check the power cord for proper installation, and make sure that the power source
is active. Be sure that the power supply is properly installed to the printer. Turn off
the printer by unplugging the power cord. Wait for 10 seconds, and turn on the
printer. If the problem remains, then replace the printer.
Service:
Go to "No power service check" on page
Technical Support Center:
Turn off the printer by unplugging the power cord. Wait for 10 seconds, and turn on
the printer. Check if the printer is seated properly on top of the second tray.
Remove the printer from the second tray, and check the tray for any visible
damage. Reinstall the second tray to the printer. If the problem remains, then
replace the printer.
Service:
Go to "Second tray not detected service check" on page
Action
"Tank receiver assembly with inlet removal"
2-78.
http://support.lexmark.com
2-78.
2-79.
2-92.
Previous
Next
Go Back