Table of Contents
Advertisement
4447-20x
Installation note: The inlet has a gasket. Install the gasket to the inlet as shown.
Installation note: Before installing the inlet to the printhead, make sure that all the tubes are straightened out,
Installation note: Follow the procedures to install the ink tubes and the printhead vent tube to the tank receiver
a.
Connect the two neoprene tubes to the regulator (A) and the printhead vent tube (B) to the neoprene
tube of the tank receiver assembly.
4-81
Service Manual
so that they do not overlap each other when installing them to the tank receiver assembly.
assembly.
A
B
Previous
Next
Go Back
Disassembly
Flow chart
Advertisement
Table of Contents
