Programmable Settings
Line Mode
If the line is connected to a low voltage system such as a PBX, set to "B"
using either the base unit or handset. Your phone comes from the factory
set to "A".
With the base unit
Make sure the base unit is not being used.
1
Press
(FUNCTION)
2
Scroll to "Initial setting" by pressing
or
Ö
Ñ,
3
Scroll to "Set tel line" by pressing
or
, and press
Ñ
Scroll to "Set line mode" by pressing
4
or
, and press
Ñ
Press
5
Ö
the line.
•The line's current setting will be displayed.
6
Select "B" or "A" by pressing
7
Press
á
•A beep sounds.
•To program the other line, start again from step 4.
•To exit the programming mode, press (STOP/EXIT).
•You can exit the programming mode any time by pressing (STOP/EXIT)
With the handset
Make sure the base unit and the handset are not being used.
Press
(CONF/FUNCTION)
of the base unit, using the handset. The display
will then show the following.
Select "B" or "A" by pressing
the right soft key (
•You can exit the programming mode any time by pressing (OFF)
22
.
and press
.
á
.
á
.
á
(Line 1) or
(Line 2) to select
Ñ
(Save).
, and follow steps 2 to 5
Ö
).
SAVE
Ö
Ö
or
.
Ö
Ñ
or
, and press
Ñ
---------------
H
Save directory
Ringer setting
Copy directory
H
Initial setting
---------------
Caller ID edit
H
Set tel line
Set answering
Set flash time
H
Set line mode
---------------
Set line mode
G
F
=Line1
=Line2
Set line mode
Line1
GF
H =Save
.
Set line mode
Line1
GF
LINE1 LINE2
S A V E
.
:A
:A