Flash Button - Panasonic KX-TG2740S Operating Instructions Manual

Special Features
Base unit
Make sure the base unit is not being used.
Press
1
(FUNCTION)
setting" by pressing
.
á
2 Scroll to "Ringer tone" by pressing
, and press
Ñ
Press
3
Ö
the line.
•The line's current setting will be displayed.
4 Select the desired ringer tone by pressing
or
Ö Ñ
•Each time you press Ö or Ñ, the tone will
change and ring. If the ringer volume has been
set to OFF for the line, the base unit will not ring
(p. 25).
•You can also select the ringer tone by pressing dialing buttons (1)
Press
5
á
•A beep sounds.
•To program the other line, start again from step 2.
To exit the programming mode, press (STOP/EXIT).
•You can exit the programming mode any time by pressing (STOP/EXIT).

FLASH Button

Pressing
(FLASH/CALL!WAIT)
your host PBX such as transferring an extension call or accessing special
telephone services (optional) such as call waiting.
•Pressing (FLASH/CALL!WAIT) causes to disable the Temporary Tone Dialing
mode or the mute (p. 76).
Selecting the flash time
The flash time depends on your telephone exchange or host PBX.
You can select the following flash times: "700, 600, 400, 300, 250, 110,
100 or 90 ms (milliseconds)", using either the base unit or handset. Your
phone comes from the factory set to "700 ms".
•If the unit is connected via a PBX, PBX functions (transferring a call etc.) might
not work correctly. Consult your PBX supplier for the correct setting.
78
, and scroll to "Ringer
Ö
.
á
(Line 1) or (Line 2) to select
Ñ
.
(Save).
or , and press
Ñ
Ö
also allows you to use special features of
Save directory
H
Ringer setting
Date and time
or
Ringer volume
H
Ringer tone
Incoming call
Ringer tone
G
=Line1
Ringer tone
Line2
GF
F
=Line2
:2
H =Save
to
(6).