The Caller Id Number Auto Edit Feature - Panasonic KX-TG2740S Operating Instructions Manual

The Caller ID Number Auto Edit Feature

There are 3 patterns of phone number (a, b, and c, p. 43, 44). This
feature allows your phone to automatically edit an in-coming Caller ID
number into one pattern you preferred, and display the Caller ID number
with that pattern automatically.
After this feature is activated, Caller ID numbers coming from considered
area codes (201, for example), from which the Caller ID numbers have
been chosen to follow the desired pattern (7 digit pattern, for example),
will be automatically edited from other patterns (11 digit pattern, for
example) into the same pattern you have previously selected (which is 7
digit pattern, in the example).
Up to 4 area codes are allowed for this feature for pattern a and b (p. 43, 44).
The Caller ID numbers can be edited automatically on the base unit and
the handset separately. Changes made on the handset cannot be used to
make a call with the base unit and vice versa.
To activate this feature, you must (1) set this feature to on, and (2) make
an out-going call from Caller List (p. 42) with a number which has one of 3
patterns that you have edited with considered area code, and that you
prefer to be followed by future Caller ID numbers, so that in the future all
the Caller ID numbers coming from the same area code will be displayed
in the same pattern.
The Caller ID number Auto Edit feature is preset to ON at factory.
•If you fail to reach your destination when making the call, the phone number you
dialed might have an incorrect pattern, please edit the phone number with another
pattern (p. 43, 44).
For example, if you move to another area, you may need to turn this
feature to OFF to erase previously edited area codes. Then, if still need,
you may activate this feature again.
Handset
Make sure the handset is not being used.
1. Press
(CONF/FUNCTION).
2. Scroll to "Initial setting" by pressing
or , and press
Ñ
3. Scroll to "Caller ID edit" by pressing
or , and press
Ñ
4. Select "On" or "Off" by pressing
5. Press the right soft key (
•A beep sounds.
•To exit the programming mode, press (OFF).
•When the feature is set to OFF, the handset will still be able to display Caller ID,
like regular Caller ID telephone, but the in-coming Caller ID number will not be
edited by pattern and by area codes.
For assistance, please call: 1-800-211-PANA(7262)
.
á
.
á
Ö
).
SAVE
Copy directory
H
Initial setting
Ö
2Way radio mode
Room monitor
H
Ö
Caller ID edit
Set tel line
Auto edit
or .
Ñ
GF
LINE1 LINE2 S A V E
:On
45