Connecting The Server To The Avaya Server Subnet (Optional); Introduction; Media Access Control Address - Avaya callpilot 1002rp Hardware Installation

Installing the server and connecting the peripheral devices

Connecting the server to the Avaya server subnet (optional)

Introduction

This section provides instructions to connect the server to the Avaya server subnet.
Note:
The Avaya server subnet is optional. However, a Avaya server subnet is required to support
desktop and Web messaging users.
Important:
To comply with EMC radiation requirements, a Class A hub must be located 10 m (33 ft.)
away from the 1002rp server. Shielded Ethernet cables must be used.

Media Access Control address

The MAC address is a unique number assigned to network cards and controllers. The
procedure below asks you to record the CLAN MAC address. The MAC address is recorded
on a label affixed to the back of the chassis.
To connect the server to the Avaya server subnet
1. See the diagram on page
2. Locate the MAC address label on the back of the chassis that identifies the CLAN
3. Record the MAC address on the Configuration Wizard worksheet that is provided
4. Connect an RJ-45 network cable from the CLAN hub or switch to the CLAN
®
52 Avaya CallPilot 1002rp Server Hardware Installation
network card.
controller MAC address.
in the Installation and Configuration Task List (NN44200-306).
You need the MAC address to identify the CLAN when running the Configuration
Wizard to configure the CallPilot server.
Note:
When connecting the optional Avaya server subnet, do not power up unless your
antivirus programs and Avaya security updates are installed first.
connector.
Rear panel connectors on page 48 to locate the CLAN
December 2010