Note:
Ensure that you have the correct cable for your modem, as follows:
56-Kbit/s modem: A0841984
Modem DIP switches
Set the modem DIP switches before you connect the modem to the CallPilot server.
Note:
This section applies only to the U.S. Robotics 56-Kbit/s external Sportster modem. If your
modem is different, refer to the documentation for your modem.
The following diagram shows the key components of the external modem, including the
location and required settings of the DIP switches:
To set the modem DIP switches
Use a pair of tweezers or a small screwdriver to set the DIP switches as described in the
Change to column of the following table:
®
Avaya CallPilot
1002rp Server Hardware Installation
Modem DIP switches
December 2010
45