Connecting The Server To The Avaya Server Subnet (Optional); Introduction - Avaya CallPilot 1006r Hardware Installation

Installing the server and peripheral devices
11. Click Finish.
12. From the Found New Hardware Wizard dialog box, select Install from a list or
13. Click Next to accept the default search and installation options.
14. Click Finish.
15. The tape drive is ready for use.

Connecting the server to the Avaya server subnet (optional)

Introduction

This section provides instructions to connect the server to the Avaya server subnet.
Note:
The Avaya server subnet is optional. However, it is required to support desktop and Web
messaging users.
Note:
If you are installing a High Availability system, do not connect either sever to the Avaya
Server Subnet. The connection to the Avaya Server Subnet is made when you configure
the system.
To connect the server to the Avaya server subnet
1. See the diagram on page
2. Connect an RJ-45 network cable from the Avaya server subnet Ethernet switch or
34 Avaya CallPilot® 1006r Server Hardware Installation
The drivers are installed.
The USB 2 SCSI adapter is detected.
specific location (Advanced) and click Next.
The installation options are displayed.
The drivers are installed.
connection.
hub to the CLAN connector.
Rear panel connectors on page 32 to locate the CLAN
December 2010