Requirements - Avaya callpilot 1002rp Hardware Installation

Installing the server and connecting the peripheral devices

Requirements

For installation, you require a Phillips No. 1 screwdriver.
To install the software feature dongle
1. Ensure that there is no cable connected to the parallel port.
2. If the software feature key is not preinstalled in the dongle, remove it from the plastic
3. Plug the male end of the adapter into the parallel port.
4. Tighten the connector screws.
®
54 Avaya CallPilot 1002rp Server Hardware Installation
Note:
The parallel port is also known as the printer port or LPT1. It is located at the back
of the server. See the diagram on page
bag, and carefully insert it into the software feature slot on the dongle. Make sure
that the clips secure it properly and that the Avaya logo faces outwards.
Rear panel connectors on page 48.
December 2010