3. Click the Save Configuration tab.
4. Ensure that the AutosavetoNvramEnabled box is not checked.
5. In the Action field, click the copyConfigToNvram button.
6. On the toolbar, click Apply.
7. On the toolbar, click Refresh to check progress.
Config/Image/Diag file tab field descriptions job aid
For more information about fields on the Config/Image/Diag file tab, see the following table.
TftpServerInetAddressType
TftpServerInetAddress
BinaryConfigFilename
BinaryConfigUnitNumber
ImageFileName
FWFileName(Diagnostics)
USBTargetUnit
Action
Fundamentals
Field name
Enterprise Device Manager configuration files
Description
Specifies the IP version of the TFTP server address
Specifies the TFTP server IP address
Specifies the name of the binary configuration file
Specifies the unit number of a switch in a stack
Specifies the software image file name
Specifies the diagnostics file name
Specifies the unit number containing the USB port
• dnldConfigFromUSB—download a configuration
to the switch from a USB device.
• DnldImgIfNewer—download a new software
image to the switch only if it is newer than the current
image.
• dnldFw—download a new diagnostic software
image to the switch.
• dnldConfig—download a configuration file to the
switch.
• upldConfigToUsb—upload a configuration file to a
USB device.
• dnldImgNoReset—download a new software
image to the switch without a switch reset.
• dnldFwNoReset—download a new diagnostic
software image to the switch without a switch
reset.
• upldConfig—upload a configuration file to the
switch from a designated location.
December 2011
67