Avaya 4550T-PWR+ Fundamentals page 59

filename <name>
unit <unit number>
The following table describes the configure network load-on-boot command
variables.
load-on-boot {disable | use-bootp | use-
config}
Viewing USB files
About this task
You can display configuration files stored on a USB device in a unit in a stack. From the ACLI
Privileged EXEC mode, enter the following command: show usb-files
Following is an output example for the show usb-files command:
ERS4000#show usb-files
USB file list - Stand-alone
Listing Directory USB_BULK:
657 Feb 17 2009 IP.CFG
6217432 Mar 3 2009 4000_53044.img
1589514 Feb 25 2009 4000_5303.bin
2048 Mar 4 2009 ABC/
Viewing USB host port information
About this task
You can display the USB host port information for a unit in a stack. From the ACLI Privileged
EXEC mode, enter the following command:
show usb-host-port [unit <1–8>]
Fundamentals
Variable
Variable
Definition
Specifies the configuration file name.
Specifies the stack unit number.
Definition
Specifies the setting to automatically load a
configuration file when the system starts
disable disables the automatic loading of the
configuration file. use-bootp specifies
loading the ASCII configuration file at startup
and using BootP to obtain values for the
TFTP or SFTP address and file name. use-
config specifies loading the ASCII
configuration file at startup and using the
locally configured values for the TFTP or
SFTP address and file name. If you omit the
variables, the system immediately
downloads and runs the ASCII configuration
file.
ACLI configuration files
December 2011 59